Ultrasonic Ground detect external control, ultrasonic generator, ultrasonic welder, ultrasonic control modul, ultrasonics

Email : info@sonic-power.com

Ultrasonic Ground detect external control

We have developed an external controller for ultrasonic ground detect that can be put on ANY ultrasonic generator no matter what brand or where it is located in the world.

Why do you need ground detect:

• Avoid damage the horn in cutting application
• Avoid damage the fixture in cutting application
• Avoid damage the knife in cutting application

Specifications:

• Line power 100 Volt – 250 Volt
• Dimensions 100mm x 100mm x 50mm
• Weight 700 gram
• Control display LED Display

Information’s provided from the screen:

• Setting of after contact time 01-9.99 seconds
• When the cycle is completed Ready
• Busy mode Busy
• We have added a signal that will be a busy signal, you can put into a PLC
• This will tell them that it is working
• It will tell them if the cut has been done correct
• In case of the ground detect is not activated the signal busy will stay on so you can have an error on the PLC after a certain time.

Setting the Ground detect:

•  1. First you need to push both buttons at the same time, to enter in the MODIFY mode,
• 2. Set New time, using the buttons up or down.
• 3. Press both buttons and to save the new time.