Ultrasonic Ground detect external control, ultrasonic generator, ultrasonic welder, ultrasonic control modul, ultrasonics

Email : info@sonic-power.com

Ultrasonic Ground detect external control

We have developed an external controller for ultrasonic ground detect that can be put on ANY ultrasonic generator no matter what brand or where it is located in the world.

Why do you need ground detect:

• Avoid damage the horn in cutting application
• Avoid damage the fixture in cutting application
• Avoid damage the knife in cutting application

Specifications:

• Line power 100 Volt – 250 Volt
• Dimensions 100mm x 100mm x 50mm
• Weight 700 gram
• Control display LED Display

Information’s provided from the screen:

• Setting of after contact time 01-9.99 seconds
• When the cycle is completed Ready
• Busy mode Busy
• We have added a signal that will be a busy signal, you can put into a PLC
• This will tell them that it is working
• It will tell them if the cut has been done correct
• In case of the ground detect is not activated the signal busy will stay on so you can have an error on the PLC after a certain time.

Setting the Ground detect:

•  1. First you need to push both buttons at the same time, to enter in the MODIFY mode,
• 2. Set New time, using the buttons up or down.
• 3. Press both buttons and to save the new time.

The post Ultrasonic Ground detect external control appeared first on Sonic-power.

The overall structure of the ultrasonic smart power Service and controller module, can be used together also with simple generator to monitor the ultrasonic frequency.

Email : info@sonic-power.com

1. Automatic tracking mode: The phase tracking mode, the two ends of the load voltage and current phase is a feedback loop, through the realization of the value of the frequency of automatic tracking.
2. Energy compensation: According to load impedance changes through computer identification and automatically adjusts compensation to flexibility in the use of explosive force, give full play to smooth out the mechanical properties change the special purpose.
3.  Quantitative control: built-in digital control in 10 to 100 percent within the framework of the quantitative output(Phase-shift control full-bridge inverter)
4. Feedback concept: the feedback factor of three parts: measurement, comparison and implementation. 。 Measurement of concern variables, and expectations, the adjustment to correct errors setting variables.
5. Slopes run output: amplitude slope upgrading, in 1 ~ 100 ms within the set.  (In the process of welding products to avoid a dislocation, damage, abnormal phenomena such as)
6. S needs of the second stage of the required amount of time.  (To meet specific technical requirements)
7. 1～8ms。 And Precision Response: adjusted response rate, set the scope of 1 ~ 8 ms. 1-10％。 1-10% accuracy adjustment.

The post Ultrasonic Service and controller module appeared first on Sonic-power.